Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Low latency audio capture and output
03-15-2015, 11:29 PM
Post: #4
RE: Low latency audio capture and output
Ok a simple example, if you don't have ASIO4ALL yet you may want to get and install it. Allows you to use ASIO on all (or most) audio devices.

Start a new application, place an ASIO component and a Scope component on the form. Something like this:

[Image: 2na21ar.png]

Now rightclick the ASIO component, click 'Select audio device'. Select your ASIO device then click on the buttons where the 2 green arrows on the right point to in the pic below. This will (re)populate the list of in- and outputs of the device.

[Image: 2s92d78.png]

Connect the Scope to output-pin0 of the ASIO component. Depending on the device selected and whether there's an audio source active on that soundsource you ought to see the Scope do what it does best.

Hope this gets you started.

Regards,
Dave
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Low latency audio capture and output - Dave - 03-15-2015, 08:18 AM
RE: Low latency audio capture and output - Dave - 03-15-2015 11:29 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)