Forums / VCL Components / VideoLab v / Any ideas on why Open() would fail?

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Any ideas on why Open() would fail?
04-04-2013, 04:35 AM
Post: #10
Dave
Unregistered
 		 
RE: Any ideas on why Open() would fail?
At least you're getting somewhere, when no devices are listed then it's hard to open one.. Hope the restore helps, otherwise it might be some DirectX thingy perhaps.

Regards,
Dave
Quote this message in a reply
Post Reply 


Messages In This Thread
Any ideas on why Open() would fail? - BReeves - 03-29-2013, 07:50 PM
RE: Any ideas on why Open() would fail? - BReeves - 03-29-2013, 10:05 PM
RE: Any ideas on why Open() would fail? - Dave - 03-30-2013, 01:19 AM
RE: Any ideas on why Open() would fail? - BReeves - 04-02-2013, 12:28 AM
RE: Any ideas on why Open() would fail? - Dave - 04-02-2013, 09:19 AM
RE: Any ideas on why Open() would fail? - Dave - 04-02-2013, 11:12 AM
RE: Any ideas on why Open() would fail? - BReeves - 04-03-2013, 06:43 AM
RE: Any ideas on why Open() would fail? - Dave - 04-03-2013, 07:43 AM
RE: Any ideas on why Open() would fail? - BReeves - 04-04-2013, 01:11 AM
RE: Any ideas on why Open() would fail? - Dave - 04-04-2013 04:35 AM
RE: Any ideas on why Open() would fail? - BReeves - 09-04-2013, 09:15 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Mitov Software | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication