Forums / VCL Components / VideoLab v / Any ideas on why Open() would fail?

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Any ideas on why Open() would fail?
04-03-2013, 07:43 AM
Post: #8
Dave
Unregistered
 		 
RE: Any ideas on why Open() would fail?
I know it will try to open some device listed, what i meant was did you verify which device is set. You write the Open() method fails, how does it fail? Which error do you get?
Quote this message in a reply
Post Reply 


Messages In This Thread
Any ideas on why Open() would fail? - BReeves - 03-29-2013, 07:50 PM
RE: Any ideas on why Open() would fail? - BReeves - 03-29-2013, 10:05 PM
RE: Any ideas on why Open() would fail? - Dave - 03-30-2013, 01:19 AM
RE: Any ideas on why Open() would fail? - BReeves - 04-02-2013, 12:28 AM
RE: Any ideas on why Open() would fail? - Dave - 04-02-2013, 09:19 AM
RE: Any ideas on why Open() would fail? - Dave - 04-02-2013, 11:12 AM
RE: Any ideas on why Open() would fail? - BReeves - 04-03-2013, 06:43 AM
RE: Any ideas on why Open() would fail? - Dave - 04-03-2013 07:43 AM
RE: Any ideas on why Open() would fail? - BReeves - 04-04-2013, 01:11 AM
RE: Any ideas on why Open() would fail? - Dave - 04-04-2013, 04:35 AM
RE: Any ideas on why Open() would fail? - BReeves - 09-04-2013, 09:15 PM

Forum Jump:


User(s) browsing this thread: 5 Guest(s)

Contact Us | Mitov Software | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication